| T O P I C R E V I E W |
| chris2006 |
Posted - 28 Feb 2020 : 18:03:11
Hi All
I need to do a small amount of editing to the silkcreen on my gerber files
I can import the files ok and make the changes but when I save the files its saving as a .pcb file
Is there anyway to save as a .gbr file ?
|
| 4 L A T E S T R E P L I E S (Newest First) |
| edrees |
Posted - 29 Feb 2020 : 10:06:23
If it is a plated through hole (or via), it may connect two or more copper layers together. Removing the through hole (or free pad?) will isolate these different layer tracks and the existing track will "repair" itself back to the normal specified track width. You may find that the sections of track adjacent to this through plated pad might also disappear -depending on its connectivity.
Experiment with EasyPC as its WYSIWYG especially if you have set up every layer (copper + non-electrical) to be visible. Keep a backup of the original file just in case. Generate the full set of new Gerbers (and Excellon drill files), then import the files into a free online Gerber viewer to see if you have achieved your objective. Best of luck! |
| chris2006 |
Posted - 28 Feb 2020 : 19:41:04
Hi Lain
One other question
I want to remove a through hole location on the PCB
When I remove the through hole location is it possible to poor copper in the hole that's left in the track?
Sorry for all the questions, Im a complete novice |
| chris2006 |
Posted - 28 Feb 2020 : 19:18:05
Hi Lain
Thanks for your help, I'll give that ago
|
| Iain Wilkie |
Posted - 28 Feb 2020 : 19:07:51
You need to generate new gerber files in the Output/Plotting and Printing.
Iain
|
