All Forums
 Help For Easy-PC Users
 Manufacturing Outputs
 How to produce X-Y Data for pick&place

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert Email Insert CodeInsert QuoteInsert List
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

 
Check here to subscribe to this topic.
   

T O P I C    R E V I E W
SparkyChris Posted - 30 Mar 2017 : 13:30:30
Hi,
I have a board that has been stepped up onto a panel (done by the PCB fabricator) and is being assembled on a pick and place line.

The assembly house have asked me for the XY Data for programming!

Can anyone tell me how to generate this data from EasyPC and what the file type would be?

Many Thanks,
Chris
5   L A T E S T    R E P L I E S    (Newest First)
DavidM Posted - 08 Apr 2019 : 08:47:34
It looks like you need to go to Settings, Folders, Report Files, and add the path to the folder that contains the report scripts. On my system this is:

C:\Users\Public\Documents\Easy-PC\Report Templates

Yours may be different, depending on what folders were chosen during install, and of course language!

David
Iain Wilkie Posted - 07 Apr 2019 : 19:38:12
Are there any reports showing ... i.e make sure you are pointed to the Reports Templates directory for EasyPC.

If its just the Component Positions report that is missing, I could email it to you.

Iain
siongboon Posted - 07 Apr 2019 : 15:51:57
Hi,

I want to generate the XY file too.
But I cannot find the "Component Positions"
from the list of reports.

OUTPUT =>Reports =>Component Positions

May I know how can I generate the XY file?
I am using version 21


Best Regards
Siong Boon

www.siongboon.com
SparkyChris Posted - 30 Mar 2017 : 19:28:42
Thanks Ed,
That seemed to generate the data I needed.
I had my PCB fab house arrange my panel, I guess that means I need to know the position of the first circuit on the panel relevant to the panel edge to figure out what offset to apply In EasyPC before generating the component position report?...hope that makes sense.

Thanks
Chris
edrees Posted - 30 Mar 2017 : 14:17:24
Hi Chris, I normally define the bottom left hand corner of the pcb the origin from where you can work out the step and repeat offset co-ordinates for each panel.

Then go to OUTPUT =>Reports =>Component Positions to produce the X/Y text file for each component (default component centre is component silk screen centre unless otherwise specified in Component Editor).

Many CEMs now use optical scanning to determine the "PIck & Place" information.