| T O P I C R E V I E W |
| AndyB |
Posted - 12 Dec 2016 : 14:09:52
I seem to have a problem switching off the top layer pads at the moment.
Since updating!
All other layers hide when selection is removed but not top layer PADS.
Any ideas what to change etc
Thanks
|
| 5 L A T E S T R E P L I E S (Newest First) |
| AndyB |
Posted - 14 Dec 2016 : 15:55:02
Looks like its a layer called "Top place bound"
Not sure how that got onto the design?
Anyway its off now :) thanks for your input.
|
| edrees |
Posted - 13 Dec 2016 : 14:54:13
You can still have a layer named "Wires" (with usage Type= Wire) in Ver. 20.0.2. If not already in your active Tech file you can add it in Design Tech. It would then also be selectable in the Layers tab. What you see when it is enabled/disabled depends on the settings you have ticked in the Design Tech table (which might be the solution to your question anyway).
|
| AndyB |
Posted - 13 Dec 2016 : 14:27:39
There was a layer called "wires" when I first purchased EPC.
That used to be a selectable layer on the pcb editor.
That used behave the same way.
|
| AndyB |
Posted - 13 Dec 2016 : 10:21:09
No This is in the pcb editor.
I'm on V19.0.6 so no backup.
So hopefully somebody on here can help out. |
| edrees |
Posted - 12 Dec 2016 : 14:54:11
Is this in the COMPONENT editor?
My top layer copper "hides" as expected in the PCB editor 20.0.2. |
